Software for the shops that make critical parts.
Quality management for CNC machine shops that supply defense, aerospace and medical-device manufacturers. Built inside a working machine shop.
Quality
OverviewInspectionsFirst articleDocumentsGaugesCalibrationRecent
FAI-0142Bracket, mountingFAI-0139Housing, sensorINS-2207Shaft, driveFirst article/FAI-0142
Bracket, mounting
In progress| No. | Characteristic | Requirement | Result | Gauge | Status |
|---|---|---|---|---|---|
| 1 | Hole diameter | Ø12.000 ±0.010 THRU | 1A 12.0041B 11.998 | GA-0231 | Accept |
| 2 | Bore finish | Ra 0.8 | 2A 0.62B 0.7 | SRF-002 | Accept |
| 3 | Overall length | 120.00 ±0.10 | 120.03 | CAL-014 | Accept |
| 4 | Thickness | 6.00 ±0.05 | 6.02 | MIC-007 | Accept |
| 5 | Hole position | Ø0.05ABC | 5A 0.0315B 0.024 | CMM-01 | Accept |
| 6 | Surface finish | Ra 1.6 | 1.2 | SRF-002 | Accept |
| 7 | Slot width | 8.00 +0.05 / 0 | — | PG-0412 | Open |
| 8 | Edge break | Note 4: remove all burrs; break sharp edges 0.2–0.4 | — | — | Open |
| 9 | Profile, all surfaces | 0.2ABC | 0.12 | CMM-01 | Accept |
Slot width
- Requirement
- 8.00 +0.05 / 0
- Gauge
- PG-0412 · Pin gauge set
- Pins
- 8.02 goes, 8.03 does not
- Calibration due
- Feb 12, 2027
GaugeFlow QMS
Inspections, first articles on AS9102 forms, document control, and gauge and calibration records.
GaugeFlow Defense
Compliance preparation for shops that do defense work.
GaugeFlow QMS
Tablet inspections
Inspectors record measurements at the machine, one characteristic at a time.
GaugeFlow ERP
Tablet clock in
Operators clock in at a shared tablet on the shop floor and start time on the operation they are running.
The screens above
Follow one first article through the QMS screens.
One sample part, the mounting bracket 40-1187-03, from its drawing to the inspections list. Every name and number is sample data.
The drawing and its revision
The documents screen shows drawing 40-1187-03 released at revision C, with revision D in review.
The first article on AS9102 Form 3
The first article screen shows FAI-0142 for part 40-1187-03, revision C, on AS9102 Form 3. Of its 17 characteristics, 14 are recorded.
Gauge and calibration records
The gauges screen lists six gauges and the date each one is due for calibration. Two are due within 30 days.
The record in the inspections list
The inspections screen lists FAI-0142 for the mounting bracket, marked in progress.
Start with QMS today. ERP is available too, and Defense is launching soon.
Contact
Tell us about your shop.
Tell us what you make and which products you want to hear about. This is where each one stands today.
- GaugeFlow QMSAvailable
- GaugeFlow ERPAvailable
- GaugeFlow DefenseLaunching soon

